- Order number: 2006633s
Built in medical Isolator - galvanic network isolation of electrical medical devices
Safety: IEC 60601-1:2005/AMD1:2012/AMD2:2020 (Edition 3.2)
EMV: EN 60601-1-2:2015 (IEC 60601-1-2:2014) (Medical electrical equipment)
In addition to network isolators with fixed cables, the medical isolator MI 1005 E offers a simple and cost-effective way to isolate medical devices, starting at the wall of the housing. This makes the insulator particularly well-suited for medical device makers. Using standard Harting PushPull technology, the MI 1005 E Medical Built In insulator can be installed quickly and easily into existing devices. Long-term availability also offers planning certainty necessary for new product development.
Under stress conditions the MI 1005 isolator was tested up to a isolation stength of 10 kV DC (10 Sec.) and 5 kV AC (60 Sec.). Furthermore, 8 kV contact discharge and 16 kV air discharge are easily fulfiled. The Network Isolator MED MI 1005 is also available as a flexible isolator or for wall mounting.
Benefits:
- Ideal for medical device makers
- Isolation starting at the wall of the device housing
- Easy installation thanks to standardized Harting PushPull technology
- Allows for planning reliability and long-term availability
- Small and lightweight at just 20 g (approx.)
- No fixed cables, easy to replace
- Harting PushPull technology, up to IP68
- Inexpensive, efficient operation, no dedicated power supply required
| Isolation Voltage: | 5,000 V |
| Data Speed: | 10/100/1000 MBit/s |
| Conformity Ethernet: | IEEE 802.3ab |
| Standards approved by: | IEC 60601-1 (Edition 3.2); IEC 60601-1-2 UL 60601 (UL Listed E504923-D1000) |
| Connections:: | 2 x RJ45 input / output |
| Material: | UL94V-0 / RoHS-compliant |
| Time between failures: | 0.21 x 10 ^ 8 (1 error in 21 million hours) |
For more information, please refer to our product information.
Conformity and Certificates:
The MI 1005 E network isolators fulfill the high requirements of current medical standards as per IEC 60601-1 (Edition 3.2) and IEC 60601-1-2. For this reason, these galvanic network isolators are ideally suited to use in medical sectors. The MI 1005 network isolators are listed for their consistent quality by UL in accordance with applicable UL standards and requirements. Representative samples of this product have been assessed by UL and fulfill the applicable safety standards. Use on US and Canadian markets is therefore possible.
Datasheet Network Isolator MI 1005 E
Brochure Network Isolators
MI_1005_E_User_Manual
